SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2001330CI CONVERTIBLE (E46) L6-3.0L (M54)REPAIR AND DIAGNOSISRESTRAINTS AND SAFETY SYSTEMSSERVICE AND REPAIRREPLACING SENSOR FOR MAIN PILLAR
2001 BMW 330Ci Convertible (E46) L6-3.0L (M54)

Replacing Sensor For Main Pillar

2001 BMW 330Ci Convertible (E46) L6-3.0L (M54)SECTION Replacing Sensor For Main Pillar



Removing And Installing/Replacing Sensor For Main Pillar

Remove left convertible top compartment lid lock.


WARNING:
Danger of locking in position!
Secure tensioning bar and convertible top compartment lid against lowering.







Open tensioning bar (1) and convertible top compartment lid (2) as illustrated.







NOTE: Do not bend deflection lever (2).


Release screw (1).
Detach deflection lever (2) and sensor for main pillar (3).







Installation:
Replace screw (2).

Ensure deflection lever (1) to sensor for main pillar (3) is correctly positioned.
Ensure screw (2) at top end of elongated hole of sensor for main pillar (3) is correctly positioned.







Loosen screws (1).
Feed sensor for main pillar (3) with plate underneath in direction of arrow out of convertible top frame (4).
Disconnect plug connection (2).
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.