Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2001330CI CONVERTIBLE (E46) L6-3.0L (M54)REPAIR AND DIAGNOSISRESTRAINTS AND SAFETY SYSTEMSSERVICE AND REPAIRREPLACING PITCH SENSOR
2001 BMW 330Ci Convertible (E46) L6-3.0L (M54)
Replacing Pitch Sensor
2001 BMW 330Ci Convertible (E46) L6-3.0L (M54)SECTION Replacing Pitch Sensor
Removing And Installing/Replacing Pitch Sensor
touring only:
Remove rear speaker on right.
Pull out cable guide (1).
Remove expansion rivet and release nuts (2).
Lift off resonance body (1) slightly.
Detach relay receptacle (2).
Disconnect plug connection (3), unclip tilt sensor (4) and remove.
Saloon/sedan, coupe, convertible:
Release right trunk wheel arch trim in rear area.
NOTE: Secure nuts (1) against falling out.
Unscrew nuts (1).
Remove holder for tilt alarm sensor (2) towards inside.
Disconnect plug.
Replacement:
Unclip tilt sensor from holder.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.