Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2001330CI CONVERTIBLE (E46) L6-3.0L (M54)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTTECHNICAL SERVICE BULLETINSALL TECHNICAL SERVICE BULLETINSCOMPUTER/CONTROLS - DME MODULE REMOVAL PRECAUTIONS
2001 BMW 330Ci Convertible (E46) L6-3.0L (M54)
Computer/Controls - DME Module Removal Precautions
2001 BMW 330Ci Convertible (E46) L6-3.0L (M54)SECTION Computer/Controls - DME Module Removal Precautions
Group 12
Engine Electrical
Bulletin Number
12 11 00
Woodcliff Lake, NJ
October 2000
Service Engineering
This bulletin is also issued in Group 24 (Automatic Transmission), S.I. 24 10 00, the contents of which are identical.
SUBJECT:
MS43 DME Removal Precautions - EGS Failure Avoidance
MODEL:
All with MS43 control unit
Situation:
The MS43 control module may stay "alive" after the key is off, due to the DM-TL test.
If the following procedure is not followed, irreparable damage to the EGS control module will occur.
PROCEDURE
1. Always verify that the ignition key is in the "off" position before disconnecting the DME.
2. Allow, at least, 3 minutes to elapse, after the key was set to the "OFF" position before disconnecting the DME. This will allow for sufficient time to complete the DM-TL test.
WARRANTY INFORMATION: For information only
Engine Electrical
Bulletin Number
12 11 00
Woodcliff Lake, NJ
October 2000
Service Engineering
This bulletin is also issued in Group 24 (Automatic Transmission), S.I. 24 10 00, the contents of which are identical.
SUBJECT:
MS43 DME Removal Precautions - EGS Failure Avoidance
MODEL:
All with MS43 control unit
Situation:
The MS43 control module may stay "alive" after the key is off, due to the DM-TL test.
If the following procedure is not followed, irreparable damage to the EGS control module will occur.
PROCEDURE
1. Always verify that the ignition key is in the "off" position before disconnecting the DME.
2. Allow, at least, 3 minutes to elapse, after the key was set to the "OFF" position before disconnecting the DME. This will allow for sufficient time to complete the DM-TL test.
WARRANTY INFORMATION: For information only
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.