Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2001330CI CONVERTIBLE (E46) L6-3.0L (M54)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSTECHNICAL SERVICE BULLETINSALL TECHNICAL SERVICE BULLETINSA/T - FAULT CODE 002 AND 003 DIAGNOSIS
2001 BMW 330Ci Convertible (E46) L6-3.0L (M54)
A/T - Fault Code 002 and 003 Diagnosis
2001 BMW 330Ci Convertible (E46) L6-3.0L (M54)SECTION A/T - Fault Code 002 and 003 Diagnosis
SI B24 12 07
Automatic Transmission
May 2007
Technical Service
SUBJECT
5HP19 - Diagnostic Information for EGS Faults (002) and (003)
MODEL
E39 with 5HP19 produced from 3/2001 to end of production
E46 with 5HP19 produced from 3/2000 to 3/2003
E46 with M56 SULEV and 5HP19 - all production
E85 with 5HP19 from SOP to 12/2005
SITUATION
The transmission Failsafe warning comes on along with a Check Engine light at times. The following fault codes are stored in EGS memory:
- Fault (002) 02 pressure actuator
- Fault (003) 03 pressure actuator
CAUSE
These faults may occur during cranking, especially during cold conditions, if the battery voltage drops below 10.5 volts.
CORRECTION
Do not replace the transmission or EGS module for these faults!
Check the battery state of charge, battery terminal connections, and charging system for the cause of the voltage drop and repair as necessary.
WARRANTY
Information only
Disclaimer
Automatic Transmission
May 2007
Technical Service
SUBJECT
5HP19 - Diagnostic Information for EGS Faults (002) and (003)
MODEL
E39 with 5HP19 produced from 3/2001 to end of production
E46 with 5HP19 produced from 3/2000 to 3/2003
E46 with M56 SULEV and 5HP19 - all production
E85 with 5HP19 from SOP to 12/2005
SITUATION
The transmission Failsafe warning comes on along with a Check Engine light at times. The following fault codes are stored in EGS memory:
- Fault (002) 02 pressure actuator
- Fault (003) 03 pressure actuator
CAUSE
These faults may occur during cranking, especially during cold conditions, if the battery voltage drops below 10.5 volts.
CORRECTION
Do not replace the transmission or EGS module for these faults!
Check the battery state of charge, battery terminal connections, and charging system for the cause of the voltage drop and repair as necessary.
WARRANTY
Information only
Disclaimer
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.