Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2001330CI CONVERTIBLE (E46) L6-3.0L (M54)REPAIR AND DIAGNOSISENGINE, COOLING AND EXHAUSTENGINESERVICE AND REPAIRPROCEDURESMOUNTING ENGINE ON ASSEMBLY STAND
2001 BMW 330Ci Convertible (E46) L6-3.0L (M54)
Mounting Engine on Assembly Stand
2001 BMW 330Ci Convertible (E46) L6-3.0L (M54)SECTION Mounting Engine on Assembly Stand
Mounting Engine On Assembly Stand
(Engine Removed)
Special Tools Required:
00 1 450 Assembly Stand
11 3 350 Locating Plate
11 8 040 Locating Plate
Remove both exhaust manifolds.
Installation:
Clean sealing faces, replace gaskets.
Coat threads with copper paste.
Replace nuts.
Tightening torque, refer to Specifications, Mechanical.
Secure engine with special tool 11 8 040 (locating plate) to special tool 00 1 450 (assembly stand).
Note: Special tool 11 3 350 (locating plate) can also be used after machining.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.