Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2001330CI CONVERTIBLE (E46) L6-3.0L (M54)REPAIR AND DIAGNOSISBODY AND FRAMELOCKSKEYLESS ENTRYKEYLESS ENTRY TRANSMITTERTESTING AND INSPECTION
2001 BMW 330Ci Convertible (E46) L6-3.0L (M54)
Keyless Entry Transmitter: Testing and Inspection
2001 BMW 330Ci Convertible (E46) L6-3.0L (M54)SECTION Testing and Inspection
INITIALIZATION OF THE TRANSMITTERS TO THE RECEIVER
1. Close all doors.
2. Turn ignition switch to the Accessory position (KL R), and then turn it off again within 5 seconds.
3. Within 30 seconds of turning the ignition switch to "off". Press and hold down the unlock button (button with the up arrow marking).
4. While holding down the unlock button, depress and release the lock button (button with the BMW logo) three times (within 10 seconds of depressing the unlock button).
5. Release the unlock button. The LED in the key will flash momentarily. The GM will immediately lock and unlock the doors signaling a successful initialization.
6. Without turning the ignition on again, repeat steps 3 through 5 for additional transmitters (up to four transmitters can be initialized to one receiver).
7. Switching the ignition to KL R completes the initialization.
1. Close all doors.
2. Turn ignition switch to the Accessory position (KL R), and then turn it off again within 5 seconds.
3. Within 30 seconds of turning the ignition switch to "off". Press and hold down the unlock button (button with the up arrow marking).
4. While holding down the unlock button, depress and release the lock button (button with the BMW logo) three times (within 10 seconds of depressing the unlock button).
5. Release the unlock button. The LED in the key will flash momentarily. The GM will immediately lock and unlock the doors signaling a successful initialization.
6. Without turning the ignition on again, repeat steps 3 through 5 for additional transmitters (up to four transmitters can be initialized to one receiver).
7. Switching the ignition to KL R completes the initialization.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.