Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2001330CI CONVERTIBLE (E46) L6-3.0L (M54)REPAIR AND DIAGNOSISACCESSORIES AND OPTIONAL EQUIPMENTNAVIGATION SYSTEMNAVIGATION MODULESERVICE AND REPAIRREPLACING NAVIGATION COMPUTER WITH CD-DRIVE
2001 BMW 330Ci Convertible (E46) L6-3.0L (M54)
Replacing Navigation Computer With CD-Drive
2001 BMW 330Ci Convertible (E46) L6-3.0L (M54)SECTION Replacing Navigation Computer With CD-Drive
Removing And Installing/Replacing Navigation Computer With CD-Drive
Special tools required:
- 65 5 400
Replacement:
Load operating software and carry out coding (refer to Diagnosis and Information System).
Touring:
Remove flap in luggage compartment trim panel on left.
Release navigation computer (1) with special tool 65 5 400 (2) and pull out.
Disconnect plug connections at the back.
Saloon/Sedan, Coupe:
Remove luggage compartment wheel arch trim on left.
Release navigation computer (1) with special tool 65 5 400 (2) and pull out.
Disconnect plug connections at the back.
Convertible:
Release navigation computer (1) with special tool 65 5 400 (2) and pull out.
Disconnect plug connections at the back.
compact:
Remove flap in luggage compartment trim panel on left.
Release navigation computer (1) with special tool 65 5 400 (2) and pull out.
Disconnect plug connections at the back.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.