Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2001330CI CONVERTIBLE (E46) L6-3.0L (M54)REPAIR AND DIAGNOSISACCESSORIES AND OPTIONAL EQUIPMENTNAVIGATION SYSTEMNAVIGATION DISPLAYSERVICE AND REPAIRREPLACING TRIM PANEL FOR ON-BOARD MONITOR (CONTROL PANEL)
2001 BMW 330Ci Convertible (E46) L6-3.0L (M54)
Replacing Trim Panel For On-Board Monitor (Control Panel)
2001 BMW 330Ci Convertible (E46) L6-3.0L (M54)SECTION Replacing Trim Panel For On-Board Monitor (Control Panel)
Replacing Trim Panel For On-Board Monitor (Control Panel)
Remove and install complete on-board monitor.
CAUTION: Place trim panel on special tool 12 7 192 (anti-static mat) and ground.
Release screws (1) and tilt trim panel out from above.
Release screws (1) and remove LC display.
Installation:
Lay wire (1) downwards.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.