Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2001320I (E46) (CANADA) L6-2.2L M54REPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - BRAKES AND TRACTION CONTROLELECTRONIC BRAKE CONTROL MODULESERVICE AND REPAIRREPLACING CONTROL MODULE FOR DSC
2001 BMW 320i (E46) (CANADA) L6-2.2L M54
Replacing Control Module For DSC
2001 BMW 320i (E46) (CANADA) L6-2.2L M54SECTION Replacing Control Module For DSC
Before starting work, rear out fault memory of ABS/DSC control module and print out diagnostic record.
Remove diagnosis socket from fixture and place to one side.
Unfasten plug connection (2) and disconnect.
Release screws (1) and carefully remove control module (3).
Installation:
Replace micro-encapsulated screws.
E46 (MK20) 2.6 Nm
E46 4X4 2.9 Nm
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.