Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2001320I (E46) (CANADA) L6-2.2L M54REPAIR AND DIAGNOSISACCESSORIES AND OPTIONAL EQUIPMENTTRIP COMPUTERSERVICE AND REPAIRREPLACING VIDEO MODULE FOR ON-BOARD MONITOR
2001 BMW 320i (E46) (CANADA) L6-2.2L M54
Replacing Video Module For on-Board Monitor
2001 BMW 320i (E46) (CANADA) L6-2.2L M54SECTION Replacing Video Module For on-Board Monitor
Removing And Installing/Replacing Video Module For On-Board Monitor
Remove panel for luggage compartment partition.
If necessary, remove transmit-receive unit.
Loosen screws (1).
Remove video module for on-board monitor (2) with bracket in direction of arrow and place to one side.
Mark antenna plugs (1) and disconnect.
Disconnect plug connections (2).
Release screw (3).
Feed video module for on-board monitor (4) in direction of arrow out of bracket and remove.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.