Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2024S3 PREMIUMREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 111 (FRONT SUSPENSION)
2024 Audi S3 Premium
Section 111 (Front Suspension)
2024 Audi S3 PremiumSECTION Section 111 (Front Suspension)
WARNING: This page is about a different car, the 2023 Audi S3, 2023 Audi RS 3, 2023 Audi A3 Quattro, and 2023 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
- 40 Front Suspension
- Front Axle
- SUBFRAME
- Suspension Strut And Upper Control Arm
- Lower Control Arm And Ball Joint
- Wheel Bearing
- Drive Axle
- Overview - Drive Axle
- Drive Axle Threaded Connection, Loosening And Tightening
- Drive Axle Heat Shield, Removing And Installing
- Drive Axle, Removing And Installing
- Drive Axle, Disassembling And Assembling
- Drive Axle, Disassembling And Assembling, Outer CV Joint, All
- Drive Axle, Disassembling And Assembling, Inner CV Joint Without Cover
- Drive Axle, Disassembling And Assembling, Inner CV Joint With Cover
- Drive Axle, Disassembling And Assembling, Inner CV Joint With Stub Shafts
- Drive Axle, Disassembling And Assembling, Inner Triple Roller Joint
- Drive Axle, Disassembling And Assembling, TENSIONING Lock Washer
- Outer CV Joint, Checking
- Inner CV Joint, Checking
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.