Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2016 Audi S8 BaseFACTORY OEM SERVICE PROCEDURE
3.1 Overview - Dynamic Steering
- Actuator
- The actuator and steering column are one component and are replaced together.
- Must not be loosened or removed from the steering column.
- Perform a basic setting on the system if the actuator was replaced. Refer to 3.3 Dynamic Steering Basic Setting.
- Steering column, removing and installing. Refer to 2.4 Steering Column (Removing and Installing).
- Active Steering Control Module - J792-
- The basic setting must be performed on the system if the Active Steering Control Module - J792- was replaced. Refer to 3.3 Dynamic Steering Basic Setting.
- Removing and installing. Refer to 3.2 Active Steering Control Module - J792-, Removing And Installing.
- Power Steering Pump
- With an electric control valve
- The power steering pump and control valve are one component and are replaced together.
- Installed position on vehicles with belt drive on the front of the engine on the left side.
- Installed position on vehicles with chain drive on the back of the engine on the left side.
- Power steering pump, removing and installing. Refer to 4.7 Power Steering Pump (Removing and Installing).
Tightening Specifications - Active Steering Control Module - J792-
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
