2016 Audi S8 BaseFACTORY OEM SERVICE PROCEDURE

3.3 Dynamic Steering Basic Setting

Special tools and workshop equipment required 

  • Steering Wheel Scales - VAS6458-
  • Wheel Alignment Computer

There Are Two Choices For Performing A Basic Setting On The Dynamic Steering: 

The "Quick Access" 

This procedure should be selected for the following activities if only the basic setting will be performed.

  • the Active Steering Control Module - J792- was replaced,
  • the Steering Angle Sensor - G85- was calibrated,
  • the steering column was replaced,
  • the steering wheel is at an angle when driving straight.

The "Complete Alignment" 

This procedure should be selected for the following activities if a basic setting and a suspension adjustment will be performed.

  • the front axle toe was adjusted,
  • the rear axle toe was adjusted,
  • the vehicle suspension was changed, for example, changing from standard to sport suspension.
NOTE:
  • Both procedures are programmed into the axle alignment computer.
  • The respective procedure is performed automatically.
  • It is only necessary to select the appropriate program for the procedure that will be performed.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.