Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
3.2 Active Steering Control Module - J792-, Removing And Installing
Special Tools And Workshop Equipment RequiredÂ
- Torque Wrench 1783 - 2-10Nm - VAG1783-
RemovingÂ
The Active Steering Control Module - J792- is located in the foot-well in front of the driver seat.
If the Active Steering Control Module - J792- is replaced, then the appropriate program must be started on the Vehicle Diagnostic Tester in "Guided Functions".
- Loosen the driver seat and push it to the rear with the wires still connected. Refer to Body Interior (Front Seats; Front Seat, Removing and Installing).
- Remove the floor mat.
- Remove the sill panel. Refer to Body Interior (Passenger Compartment Trim; Sill Panel Strip, Removing and Installing).
- Remove the foot rest. Refer to Body Interior (Passenger Compartment Trim; Foot Rest, Removing and Installing).
- Remove the cover -1- for the emergency release -arrows-.
- Disconnect the floor covering and push it to the side, then guide the cover -1- for the emergency release through the opening.
- Remove the nuts -arrows-.
- Swivel the actuator for the emergency release -1- to the side.
- Remove nuts -6-.
- Remove the nuts -1- and remove the ground wire -2- from the threaded pin.
- Carefully disconnect the wiring harness clip connection -3- from the bracket -4-.
- Remove the bolts -5- from the control module -7- and remove the bracket -4-.
- Disconnect the wiring harness connector -3- from the control module -7-.
InstallingÂ
Installation is the reverse of removal, with special attention to the following:
Follow the sequence when installing the control module:
- Attach the bracket -4- to the control module-7- with the bolts -5-.
- Connect the wiring harness connectors -3- to the control module -7-.
- Carefully slide the wiring harness clip connection -3- into the bracket -4-.
- Insert the control module with the bracket.
- Connect the ground wire -2- to the threaded pin and tighten the nuts -1-.
- Tighten nuts -6-.
- The basic setting must be performed on the system if the Active Steering Control Module - J792- was replaced. Refer to 3.3 Dynamic Steering Basic Setting.Â
Tightening SpecificationsÂ
- Refer to Body Interior (Front Seats; Overview - Front Seat).
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
