Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2016 Audi S8 BaseFACTORY OEM SERVICE PROCEDURE
Section 1005 (Anti-Lock Brake System (Abs) And Stability Control)
WARNING: This page is about a different car, the 2017 Lincoln Navigator and 2017 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Description And Operation
- Anti-Lock Control
- Overview
- System Operation
- System Diagram
- Network Message Chart
- Anti-Lock Brake System (ABS) Function
- Electronic Brake Distribution (EBD)
- Supplemental Braking Assist
- Traction Control Function
- Electronic Stability Control (ESC)
- Roll Stability Control (RSC)™
- Curve Control
- Trailer Sway Control
- Hill Descent Control™
- Hill Start Assist
- MyKey ® Interaction
- Stability-Traction Control Indicator (Sliding Car Icon)
- Stability-Traction Control Disabled Indicator (Sliding Car OFF Icon)
- Component Description
- Anti-Lock Control
- Diagnosis And Testing
- Anti-Lock Control
- Notes
- DTC Chart: ABS Module
- Symptom Chart
- Pinpoint Tests
- Pinpoint Test A : B1676
- Pinpoint Test B : B2900
- Pinpoint Test C : C1300
- Pinpoint Test D : C1145, C1155, C1165, C1175
- Pinpoint Test E : C1222, C1296, C1297, C1298, C1299
- Pinpoint Test F : C1266
- Pinpoint Test G : C116A, C1440
- Pinpoint Test H : C109D, C109E, C109F
- Pinpoint Test I : The Hill Descent Control System Is Inoperative
- Pinpoint Test J : U0100, U0401
- Pinpoint Test K : U0114, U0414
- Pinpoint Test L : C1278, U0131, U0428
- Pinpoint Test M : U0140, U2152
- Pinpoint Test N : U0155, U0423
- Pinpoint Test O : Stability Control Sensor Signal And Circuit Faults
- Pinpoint Test P : The Stability-Traction Control System Is Inoperative Or Cannot Be Disabled
- Pinpoint Test Q : DTC U0151, U0452
- Anti-Lock Control
- Removal And Installation
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
