2016 Audi S8 BaseFACTORY OEM SERVICE PROCEDURE

Stability-Traction Control Switch

WARNING: This page is about a different car, the 2017 Lincoln Navigator and 2017 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

The stability-traction control switch is a single-pole, momentary-contact switch. On Expedition vehicles, the stability-traction control switch is part of a 3-switch pack containing the stability-traction control switch, the Hill Descent Control™ switch (if equipped) and the power liftgate switch (if equipped). On Navigator vehicles, the stability-traction control switch is part of the Front Controls Interface Module (FCIM) and is serviced with the FCIM.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.