2016 Audi S8 BaseFACTORY OEM SERVICE PROCEDURE

Anti-Lock Brake System (ABS) Module

WARNING: This page is about a different car, the 2017 Lincoln Navigator and 2017 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

The ABS module is attached directly to the HCU and is the ECU for all of the stability control systems. The module monitors all sensor inputs and all HS-CAN messages relating to vehicle dynamics and directly controls the solenoid valves and the hydraulic pump motor.

The ABS module is available separately for service. When a new ABS module is installed, whether with a new HCU or not, the module must be programmed with the vehicle information. Refer to Description and Operation in Module Configuration .

When a stability control system fault has been corrected or a component has been replaced, the ABS module requires calibration. The calibration procedure is required for the stability control sensors to learn the "zero-position" of the vehicle which means the vehicle must be on a level surface and must not be moving. The calibration procedure is carried out using a diagnostic scan tool.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.