Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Rearview Camera, Calibrating
-- Set-up requirements, refer to Calibration Requirements .
-- Connect Vehicle Diagnostic Tester.
Attaching the Calibration Tool - Wheel Center MountingsVAS6350/1:
-- Check the dimension of the holes.
-- Equip the Calibration Tool - Wheel Center MountingsVAS6350/1 appropriately. Use spacer pieces.
-- To do this, secure three wheel bolt adapters in the hole circle to each Calibration Tool - Wheel Center MountingsVAS6350/1.
-- Place the paddle on both Calibration Tool - Wheel Center MountingsVAS6350/1 and secure them using a clamping screw.
-- Place the Calibration Tool - Wheel Center MountingsVAS6350/1 onto the wheel bolts on the rear wheels.
The Calibration Tool - Wheel Center MountingsVAS6350/1 are positioned by the "O rings" in the adapters and held in place.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.