Calibration Requirements

• The camera lens must be clean. Cleaning
• Check the camera images on the Front Information Display Control Head -J685-. Replace the camera if the images are unclear because the camera has been damaged. Check the mount for the camera if the image is low.
• Make sure both exterior rearview mirrors are folded out.
• The vehicle must be standing on a firm and level surface.
• There must be enough clearance around the vehicle (at least 2 meters).
• The parking brake must be set.
• The steering wheel must be in the 0 position and the wheels must be straight.
• If the vehicle has an air suspension, turn on "Auto" and drive the vehicle at "standard vehicle height" onto Vehicle Diagnostic Tester.
• All doors and the rear lid must be closed.
• No one should be in the vehicle.
• The vehicle must not be loaded (curb weight).
• Connect the battery charger.
• Ignition switched on.
• The system is active and is displayed on the Front Information Display Control Head -J685-.
• Do not move the vehicle during the calibration process.

Calibrate the cameras in the following sequence:

• Front Peripheral Camera -R243-
• Rear Peripheral Camera -R246-
• Left Peripheral Camera -R244-
• Right Peripheral Camera -R245-

Special tools and workshop equipment required 

• Calibration ToolVAS6350
• Peripheral Camera Calibration DeviceVAS6350/6
• Vehicle Diagnostic Tester

The Calibration ToolVAS6350 consists of the following parts:

• Calibration field
• Calibration Tool - Wheel Center MountingsVAS6350/1
• Calibration Tool - Spacing LaserVAS6350/2
• Linear LaserVAS6350/3A

The Peripheral Camera Calibration DeviceVAS6350/6 is comprise of the following components:

• Mounting Post with Left PlateVAS6350/6-1
• Mounting Post with Right PlateVAS6350/6-2
• Left Post MountVAS6350/6-3
• Right Post MountVAS6350/6-4
• Guide PinVAS6350/6-5
• Line Scan Laser MountVAS6350/6-6

Overview Calibration ToolVAS6350 with Peripheral Camera Calibration DeviceVAS6350/6

The Mounting Post with Left PlateVAS6350/6-1 and Mounting Post with Right PlateVAS6350/6-2 must be vertical.

-- Move the calibration field on the Peripheral Camera Calibration DeviceVAS6350/6 into a horizontal position.

-- To do this, twist plastic feet under the calibration field of the Calibration ToolVAS6350 so that air bubble in level is located exactly in the center of the indicator -arrow-