Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Zero position (link guide), adjusting
2007 Audi S8SECTION Zero position (link guide), adjusting
Drive motor removed, but electrical wires connected.
- Switch on ignition
- Move automatic rotary switch to "roof closed" position.
- Drive motor runs to "zero" position automatically and cuts out.
- Switch off ignition.
- The viewing window is protected by a cover. Pry out cover - 1 -.
- The colored marking - 2 - in viewing window and the protruding tab - 3 - must align.
- Install drive motor in this position (zero position) with sunroof closed.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.