Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Throttle Cable
When installing a throttle cable, ensure it is aligned properly between its supports and fixing points. Throttle cable is fixed to accelerator pedal and cam disc. Longitudinal adjustment of throttle cable sleeve is not fixed by securing clip.
1) Fully depress accelerator pedal. Pull back throttle cable sleeve until throttle valve lever rests on the full load stop. See "A" in Fig 1 . Secure longitudinal adjustment using securing clip. See "B" in Fig 1 .
2) Depress accelerator pedal fully. Throttle valve lever must rest on the full load stop. Release accelerator pedal completely. Throttle lever must come to rest at idle stop. See Fig 2 . Repeat adjustment if conditions are not met.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.