Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSACURA2008TSX AUTOMATICREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSOPENERSHOOD LATCH REPLACEMENT

2008 Acura TSX Automatic

Hood Latch Replacement

2008 Acura TSX AutomaticSECTION Hood Latch Replacement

Remove the front grille cover (see FRONT GRILLE REPLACEMENT ).
Remove the bolts, then remove the hood latch cover (A) from the hood latch (B).

Fig 1: Removing Hood Latch Cover From Hood Latch w/Torque Spec.
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Disconnect the hood latch switch connector (A).

Fig 2: Disconnecting Hood Latch Switch Connector
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the bolts, then remove the hood latch (A) from the body.

Fig 3: Removing Hood Latch From Body w/Torque Spec.
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Disconnect the hood opener cable (B) from the hood latch. Take care not to kink the cable.
Install the latch in the reverse order of removal, and note these items:
- Apply multipurpose grease to each location of the hood latch indicated by the arrows.
- Make sure the hood opener cable is connected properly and hood latch switch connector is plugged in properly.
- Adjust the hood latch alignment (see HOOD ADJUSTMENT ).
- Make sure the hood opens properly and locks securely.
  
  Fig 4: Disconnecting Hood Opener Cable From Hood Latch
  Courtesy of AMERICAN HONDA MOTOR CO., INC.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.