Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Rear Cover: Reassembly
2004 Acura 3.5RLSECTION Reassembly
- To reassemble reverse idler gear, coat components with ATF. Install thrust washers, needle bearings, reverse idler gear and reverse idler gear shaft. Ensure reverse idler gear is installed with offset area in correct direction. See Fig 1.
- Install reverse idler gear shaft holder. Install and tighten bolts to specification. See TORQUE SPECIFICATIONS .
- To reassemble reverse and 2nd clutch feed pipes, reverse disassembly procedure using NEW "O" rings. Coat components with ATF before reassembly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.