SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA20043.5RLREPAIR AND DIAGNOSIS (SINGLE PAGE)EXTERNAL PAGESDIFFERENT CARSECTION 37 (WHEEL ALIGNMENT SPECIFICATIONS & ADJUSTMENT PROCEDURES)WHEEL ALIGNMENT PROCEDURESTOE-IN ADJUSTMENTREAR
2004 Acura 3.5RL

Toe-In Adjustment: Rear

2004 Acura 3.5RLSECTION Rear
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2003 Acura RSX, 2003 Acura MDX, 2003 Acura 3.5RL, 2003 Acura 3.2TL, and 2003 Acura 3.2CL. However, it is still accessible from the selected car via links, so may be relevant.

Release parking brake. If parking brake is engaged, toe-in measurement may be incorrect. Hold adjuster bolt on lower control arm, and loosen lock nut. See Fig 1 . Turn adjuster bolt until toe-in is as specified. See WHEEL ALIGNMENT SPECIFICATIONS  . Install NEW lock nut, and tighten to specification. See TORQUE SPECIFICATIONS  .

Fig 1: Adjusting Rear Toe-In (Typical)
G92A00968Courtesy of AMERICAN HONDA MOTOR CO., INC.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.