Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal & Installation (Integra Sedan)
Release fuel system pressure. See INTEGRA & 3.5RL under FUEL SYSTEM PRESSURE RELEASE. Depress two front latch tabs on rear seat bottom cushion and lift up and forward to remove seat bottom cushion. Remove fuel tank unit access panel. Disconnect electrical connector and fuel lines. Remove fuel tank unit mounting nuts. Lift out fuel pump. To install, reverse removal procedure. Install NEW fuel pump "O" ring and fuel line retainer.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.