Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Integra & 3.5RL
Disconnect negative battery cable. Loosen fuel tank filler cap. Place clean shop rag around fuel filter. On models equipped with special service bolt (located in end of fuel filter banjo bolt), slowly loosen service bolt on top of fuel filter one complete turn to relieve system pressure. On models not equipped with a service bolt, slowly loosen banjo bolt on top of fuel filter one complete turn to relieve system pressure. Always replace washers after loosening service or banjo bolt.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.