Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA1998INTEGRA RS, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)TRANSMISSIONAUTOMATIC TRANSAUTOMATIC TRANSMISSION OVERHAUL - S4XATESTINGHYDRAULIC PRESSURE TESTCLUTCH PRESSURE TEST
1998 Acura Integra RS, Automatic
Clutch Pressure Test
1998 Acura Integra RS, AutomaticSECTION Clutch Pressure Test
- Clutch pressure should be checked at each clutch pressure tap on transaxle. See Figure .
- With engine off, remove pressure plug from appropriate clutch pressure tap on transaxle. See Figure
. Attach Pressure Gauge Set (07406-0020400) to appropriate pressure tap using NEW seal washer. Tighten hose fitting to 13 ft. lbs. (18 N.m).NOTE: On some applications clutch pressure may vary with position of throttle control lever on transaxle. Throttle Valve (T.V.) cable is connected to throttle control lever on transaxle. T.V. cable may need to be disconnected from throttle control lever for some tests. Ensure shift lever is in proper position when checking clutch pressures.
- Start and operate engine at 2000 RPM. Note clutch pressure reading with shift lever in proper location. Refer to specifications in HYDRAULIC PRESSURE TEST SPECIFICATIONS table.
- Clutch pressure should be within specification. If not within specification, see HYDRAULIC PRESSURE TROUBLE SHOOTING table. Shut engine off.
- Using NEW seal washer, install and tighten pressure tap plug to specification. See TORQUE SPECIFICATIONS .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.