Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Active Safety Domain Master (ASDM) [2016-2020]: Removal
Set the vehicle to Inactive mode, described in user mode, refer to: USAGE MODE
Remove the marked part.
Remove the marked part.
Remove the marked part.
The graphic shows the back of the component before removal.
Remove the marked part.
Disconnect the connector.
Disconnect the connector.
Disconnect the connector.
Remove the screws.
Loosen the clip.
Remove the marked part.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.