Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Controlling Charging
The Engine Control Module (ECM) (4/46) regulates the charge voltage of the alternator (GEN) (6/26) (via LIN communication) when requested by the Central Electronic Module (CEM) (4/56) (via CAN communication).
The Engine Control Module (ECM) can change the requested charging voltage from the Central Electronic Module (CEM) in order to adapt it to certain operating conditions such as starting, idling or high engine loads.
The value of requested charge voltage from the Engine Control Module (ECM) and the charge current of the generator can be read off.
The Alternator Control Module (ACM) (6/26) transmits information to the Engine Control Module (ECM) regarding any faults. The Diagnostic Trouble Codes (DTCs) are stored in the Engine Control Module (ECM) in the event of a fault. In the event of certain faults, information about these faults is also transmitted to the Central Electronic Module (CEM).
For additional information on regulating the alternator, see appropriate Design and Function information for the Alternator and for the Central Electronic Module (CEM).
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.