Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSVOLVO2017XC60 T6 INSCRIPTIONREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSDOORS AND LIDS - DESIGN AND FUNCTIONPOWER OPERATED TAILGATE MODULEPOWER OPERATED TAILGATE MODULE (POT) [2009-2011]SYSTEM OVERVIEWSIGNALS

2017 Volvo XC60 T6 Inscription

System Overview: Signals

2017 Volvo XC60 T6 InscriptionSECTION Signals

The table below summarizes input and output signals to and from the Power Operated Tailgate Module (POT). The illustration below displays the same information with the Volvo component designations.

Input signals	Output signals
Directly connected:	Directly connected:
Switch handle 3/35 Switch closing tailgate (3/291) Lock motor central locking system tailgate (6/8), sensor 1 and 2 Trap sensor (7/227A, 7/227B), signal (Only found on vehicles manufactured up to and incl. structure week 200947) 30-supply, power supply Ground, power supply	Motor closing tailgate (6/149), closing and reversible operation Hydraulic pump (6/148), opening and closing of tailgate Control valve, signal (7/220)
Via Controller Area Network (CAN) communication:	Via Controller Area Network (CAN) communication:
Central electronic module (CEM) (4/56) Keyless vehicle module (KVM) (4/93)	Central electronic module (CEM) (4/56)

Courtesy of VOLVO CARS CORPORATION

NOTE:

Pinch sensors (7/227 A and 7/227 B) are only found on vehicles manufactured up to and incl. structure week 200947.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.