Stability Control

2017 Volvo S60 T5 Dynamic, 2.0L Eng VIN 40SECTION Stability Control

Stability is controlled by the brake control module (BCM) sending a signal to the engine control module (ECM) to reduce engine torque if a drive wheel should start to spin and there is a reduction in road grip. Stability control is operable between 0 km/h (0 mph) and top speed. For traction control, see TRACTION CONTROL .

GLL153879Courtesy of VOLVO CARS CORPORATION

Applies for V70 (08-), XC70 (08-), S80 (07-), XC60, (structure week -201119) 

Stability control can be engaged or disengaged manually by turning the function selector on the left steering wheel stalk until "DSTC/ESC/spin control on/off" appears in the driver information module display. The selection is then confirmed by pressing the "Reset" button. All functions are connected when the ignition is turned on. If the stability function is disengaged, the other functions will operate normally.

Applies for S60 (11-) (structure week 201020-), and for S80 (07-), V70 (08-), XC70 (08-), V60, XC60, (structure week 201120-) 

The stability function (Stability Control) can be activated and deactivated via the menu in Infotainment Control Module (ICM). When the ignition is turned on all functions are engaged. If the stability function is turned off the other functions work normally.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.