Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO2010XC70 AWD L6-3.2L VIN 96 B6324S2REPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - LIGHTING AND HORNSTRAILER LIGHTING MODULETESTING AND INSPECTIONSCAN TOOL TESTING AND PROCEDURESVEHICLE COMMUNICATION INFORMATION, TRAILER MODULE (TRM)DESCRIPTION OF PARAMETERS
2010 Volvo XC70 AWD L6-3.2L VIN 96 B6324S2
Description Of Parameters
2010 Volvo XC70 AWD L6-3.2L VIN 96 B6324S2SECTION Description Of Parameters
Description of parameters
Parameters, status
Note! When reading off signals activated by the trailer module (TRM), there should not be any trailer connectors plugged into the socket of the vehicle's tow hitch. The trailer connector may only be plugged into the socket if the cable harness and its connectors are checked and fault-free.The socket for the tow hitch connector is available in several variants with different numbers of poles. The output signals for back-up (reversing) lamps, fog lamps and charging (+12 V) is market dependent.
Tow hitch connector connected
Indicates if the trailer module (TRM) registers that the tow hitch connector is connected to the socket.
Yes = tow hitch connector is connected.
No = tow hitch connector is not connected.
Back-up (reversing) lamps
Indicates if the trailer module (TRM) has activated the signal for the back-up (reversing) lamp.
On = back-up (reversing) lamp activated.
Off = back-up (reversing) lamp not activated.
Fog lamps
Indicates if the trailer module (TRM) has activated the signal for the fog lamp.
On = fog lamp activated.
Off = fog lamp not activated.
Parking lamps
Indicates if the trailer module (TRM) has activated the signal for the parking lamp.
On = parking lamps activated.
Off = parking lamps not activated.
Stop lamp, right
Indicates if the trailer module (TRM) has activated the signal for the right-hand stop lamp.
On = right-hand stop lamp activated.
Off = right-hand stop lamp not activated.
Stop lamp, left
Indicates if the trailer module (TRM) has activated the signal for the left-hand stop lamp.
On = left-hand stop lamp activated.
Off = left-hand stop lamp not activated.
Stop lamp, input signal
Indicates if the trailer module (TRM) receives an input signal for the stop lamp from the central electronic module (CEM).
On = input signal for stop lamp received.
Off = input signal for stop lamp not received.
Right turn signal lamp
Indicates if the trailer module (TRM) has activated the signal for the right-hand turn signal lamp.
On = right-hand turn signal lamp activated.
Off = right-hand turn signal lamp not activated.
Left turn signal lamp
Indicates if the trailer module (TRM) has activated the signal for the left-hand turn signal lamp.
On = left-hand turn signal lamp activated.
Off = left-hand turn signal lamp not activated.
Charging
Indicates if the trailer module (TRM) has activated the signal for charging (+12 V).
On = charging (+12 V) activated.
Off = charging (+12 V) not activated.
Parameters, value
Battery voltage, TRM
Indicates the value of the power supply to the trailer module (TRM).
Measurement range: 0 -25.5 V.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.