Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO2010XC70 AWD L6-3.2L VIN 96 B6324S2REPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - BRAKES AND TRACTION CONTROLPARKING BRAKE CONTROL MODULESERVICE AND REPAIR
2010 Volvo XC70 AWD L6-3.2L VIN 96 B6324S2
Parking Brake Control Module: Service and Repair
2010 Volvo XC70 AWD L6-3.2L VIN 96 B6324S2SECTION Service and Repair
Parking brake module
Operation number: 55105-2
Note! Some variation in the illustrations may occur, but the essential information is always correct.
Removal
Note! Removal steps in this procedure may contain installation details.
Remove the left hand side panel. Refer to: Side panel loadspace Side Panel Loadspace
Note! Make sure that the component terminals are not bent or damaged.
Torque: Control module parking brake console, 7 Nm
Installation
Caution! Make sure that new nuts are installed.
To install, reverse the removal procedure
Order software for the control module.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.