Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO2010XC70 AWD L6-3.2L VIN 96 B6324S2REPAIR AND DIAGNOSISA L L DIAGNOSTIC TROUBLE CODES ( DTC )TESTING AND INSPECTIONP CODE CHARTSP0615P061512 (ENGINE CONTROL MODULE - ECM)DIAGNOSTIC TROUBLE CODE (DTC) INFORMATION
2010 Volvo XC70 AWD L6-3.2L VIN 96 B6324S2
Diagnostic Trouble Code (DTC) Information
2010 Volvo XC70 AWD L6-3.2L VIN 96 B6324S2SECTION Diagnostic Trouble Code (DTC) Information
Diagnostic trouble code (DTC) information ECM-P061512
Condition
The engine control module (ECM) checks the signal of the starter motor relay coil. The diagnostic trouble code (DTC) is stored if the engine control module (ECM) detects that the signal is high despite the ignition switch being in position II (ignition position).
The diagnostic trouble code can be diagnosed when the ignition is on.
Substitute value
- Nothing.
Possible source
- The signal cable is short-circuited to voltage.
- Damaged starter motor relay.
Fault symptom[s]
- Nothing
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.