Diagnostic Trouble Code (DTC) Information

2010 Volvo XC70 AWD L6-3.2L VIN 96 B6324S2SECTION Diagnostic Trouble Code (DTC) Information





Diagnostic trouble code (DTC) information ECM-P033121

Condition




The knock sensor signal varies with engine speed. The engine control module (ECM) checks that the knock sensor signal is within certain limits, which are determined by engine speed. The diagnostic trouble code is generated if the signal from the knock sensor is not within the limit values.
The diagnostic trouble code can be diagnosed during a road test.
The diagnostic trouble code refers to knock sensor 2.

Substitute value
- Ignition angle reduction for reasons of safety.

Possible source
- Contact resistance or oxidation in the connector for the knock sensor (KS).
- Loosely installed knock sensor (KS).
- Damaged knock sensor (KS).

Fault symptom[s]
- Poor performance.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.