Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO2010XC70 AWD L6-3.2L VIN 96 B6324S2REPAIR AND DIAGNOSISA L L DIAGNOSTIC TROUBLE CODES ( DTC )TESTING AND INSPECTIONP CODE CHARTSP0111P011124 (ENGINE CONTROL MODULE - ECM)DIAGNOSTIC TROUBLE CODE (DTC) INFORMATION
2010 Volvo XC70 AWD L6-3.2L VIN 96 B6324S2
Diagnostic Trouble Code (DTC) Information
2010 Volvo XC70 AWD L6-3.2L VIN 96 B6324S2SECTION Diagnostic Trouble Code (DTC) Information
Diagnostic trouble code (DTC) information ECM-P011124
Condition
The engine control module (ECM) checks the signal from the air temperature sensor in the intake manifold.
The diagnostic trouble code is generated if the control module detects that the value from the air temperature sensor deviates too much from the engine temperature, outside temperature or fuel temperature after the engine has been off for a long period of time.
The diagnostic trouble code can be diagnosed once per operating cycle with the ignition on, but only once engine temperature has fallen to approx. 55 °C from operating temperature since the previous operating cycle.
Substitute value
- The value for the inlet temperature is generated to equal to the value for the fuel temperature.
Possible source
- Contact resistance in connector.
- Damaged air temperature sensor (integrated in mass air flow sensor).
Fault symptom[s]
- Malfunction indicator lamp (MIL) lit.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.