Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO2010XC70 AWD L6-3.2L VIN 96 B6324S2REPAIR AND DIAGNOSISA L L DIAGNOSTIC TROUBLE CODES ( DTC )TESTING AND INSPECTIONC CODE CHARTSC0063C006328 (BRAKE CONTROL MODULE - BCM)FAULT-TRACING INFORMATION
2010 Volvo XC70 AWD L6-3.2L VIN 96 B6324S2
Fault-Tracing Information
2010 Volvo XC70 AWD L6-3.2L VIN 96 B6324S2SECTION Fault-Tracing Information
Fault-tracing
Checking the component
The diagnostic trouble code (DTC) indicates that the body sensor cluster (BSC) has an internal fault.
Replace the body sensor cluster (BSC).
Other information
- Accelerometer and yaw angle sensor Service and Repair
Continue - Verification
-------------------------------------------------
Verification
Hint: After carrying out the repair, check that the fault has been remedied.
- Ignition off.
- Reconnect the connectors, reinstall components etc.
- Test drive the vehicle following:
- Ignition on.
Read off the status of the diagnostic trouble code (DTC).
Is the status of the diagnostic trouble code (DTC) intermittent?
Yes - FAULT FOUND
No - Fault-tracing information
-------------------------------------------------
Fault-tracing information
Attempt New Test - Checking the component
-------------------------------------------------
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.