Diagnostic Trouble Code (DTC) Information

2010 Volvo XC70 AWD L6-3.2L VIN 96 B6324S2SECTION Diagnostic Trouble Code (DTC) Information





Diagnostic trouble code (DTC) information

Condition
The Driver door module (DDM) supplies voltage to the lock motor, blocked lock position.
The diagnostic trouble code (DTC) is stored if the control module detects that:
- Signal too low from the output.
The control module's test for the diagnostic trouble code (DTC) starts in the event of:
- Activation of blocked lock position.

Note! The control module can only detect the fault once the test has been started and the diagnostic trouble code (DTC) is stored when the conditions are met.

Substitute value
- None.

Possible source
- Short-circuit to ground in the power supply cable.

Fault symptom[s]
- Does not lock to the deadlock position BLL

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.