Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO2010XC70 AWD L6-3.2L VIN 96 B6324S2REPAIR AND DIAGNOSISA L L DIAGNOSTIC TROUBLE CODES ( DTC )TESTING AND INSPECTIONB CODE CHARTSB1027B102796 (SUPPLEMENTAL RESTRAINT SYSTEM MODULE - SRS)DIAGNOSTIC TROUBLE CODE (DTC) INFORMATION
2010 Volvo XC70 AWD L6-3.2L VIN 96 B6324S2
Diagnostic Trouble Code (DTC) Information
2010 Volvo XC70 AWD L6-3.2L VIN 96 B6324S2SECTION Diagnostic Trouble Code (DTC) Information
Diagnostic trouble code (DTC) information SRS-B102796
Condition
The Supplemental restraint system module (SRS) checks internal components in the seat belt (inertia) reel sensor, driver's.
The diagnostic trouble code (DTC) is stored if the control module detects that:
- Internal components do not work.
- Incorrect value runs longer than 2.5 seconds.
The control module's test for the diagnostic trouble code (DTC) starts in the event of:
- Ignition position II and III. Only during start-up of the supplemental restraint system.
Note! The control module can only detect the fault once the test has been started and the diagnostic trouble code (DTC) is stored when the conditions are met.
Substitute value
- None.
Possible source
- Damaged driver's seat belt (inertia) reel sensor.
Fault symptom[s]
- SRS warning light on
- SRS warning message displayed
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.