Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO2009XC90 BASE, AWDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTHEADLIGHTSELECTRICAL - SYMPTOM RELATED DIAGNOSTIC PROCEDURES - 1 OF 2CHECKING REMOTE CONTROLS (2003-2014)CHECKING THE REMOTE CONTROLINTERIOR LIGHTING AND UPPER ELECTRONIC MODULE (UEM), REPLACINGINSTALLING THE CONTROL MODULE
2009 Volvo XC90 Base, AWD
Installing The Control Module
2009 Volvo XC90 Base, AWDSECTION Installing The Control Module
- Screw the control module screw into place.
- Connect the connector for the control module.
- Reinstall the cover for the control module connector.
- Connect the 2 connectors.
- Press the bulb holder into place.
- Install the ground lead.
- Install the 2 screws at the front edge.
- Install the lens.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.