Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Wheel Brakes, General
| Number | Designation | Number | Designation |
| 1 | Brake caliper | 7 | Bleed nipple |
| 2 | Holder | 8 | Piston |
| 3 | Rubber bushing | 9 | Brake fluid inlet |
| 4 | Sliding pin | 10 | Sealing ring |
| 5 | Brake pads | 11 | Dust boot |
| 6 | Brake hose |
The vehicle has disc brakes on all four wheels to ensure optimum braking performance. The foot brake is combined with the parking brake on the rear axle.
The brake discs are ventilated on the front axle and are available in different diameters depending on engine type. There are three different types of rear brake discs.
- ventilated disc for electric parking brake
- solid disc for electric parking brake
- solid disc for foot operated mechanical parking brake.
The brake caliper (1) consists of two parts, housing and holder. The caliper grips across the disc brake and slides in the holder on two sliding pins (4). The sliding pins are greased and protected with a rubber bushing (3). The braking force from the brake pads (5) is absorbed via the holder (2), which transfers the force to the spindle.
The sliding pins are made of steel. They are screwed into the holder, which is secured to the stub axle.
The brake caliper contains a piston (8) together with a sealing ring (10) and dust boot (11). The piston cylinder is made of steel.
The piston presses directly on the internal brake pad. Based on the action-reaction principle, the caliper (1) presses backwards. Through this movement, the outer brake pad presses against the brake disc.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.