Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Switches In The Lock Units
A contact breaker is mounted in the lock units on the side doors and trunk lid/tailgate to indicate if any of them are open or closed. On vehicles with an alarm there is a single switch on the hood. The switches are closed when the door or tailgate/trunk lid is shut.
When the alarm is activated, the central electronic module (CEM) checks every 3 times / second that the switches are closed. If the central electronic module (CEM) detects that a switch is open the alarm is triggered.
If the central electronic module (CEM) detects that a switch is not closed when a lock command for locking the central locking system and alarm activation is received, the vehicle tilt sensor and movement sensor will not be activated. When the last door or hatch is closed, all alarm functions are activated, including movement sensor/vehicle tilt sensor after the initial time delay of 11 seconds.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.