Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Power Steering Control Module (PSCM) And Steering Wheel Angle Sensor Module (SAS) - Specifications
2009 Volvo S80 BaseSECTION Power Steering Control Module (PSCM) And Steering Wheel Angle Sensor Module (SAS) - Specifications
- Power Steering Control Module (PSCM) (2011-2012)
- Steering Wheel Angle Sensor Module (SAS)
- Description Of Parameters (2007-2009)
- Description Of Parameters (2010-2012)
- Description Of Reading Off Of Extended Diagnostic Trouble Code (DTC) Information (2007-2009)
- Contents
- Description Of Frozen Values
- General
- Global Time
- Total Mileage
- Power Supply, Central Electronic Module (CEM)
- Engine Running
- Passenger Compartment Temperature
- Outside Temperature
- Power Supply Mode, Status
- Power Supply, Steering Wheel Angle Sensor Module (SAS)
- Steering Wheel Angle
- Steering Wheel Angle Speed
- Steering Wheel Angle, Steering Direction
- Description Of Reading Off Of Extended Diagnostic Trouble Code (DTC) Information (2010-2012)
- Contents
- Description Of Frozen Values
- General
- Global Time
- Total Mileage
- Power Supply, Central Electronic Module (CEM)
- Engine Running
- Passenger Compartment Temperature
- Outside Temperature
- Power Supply Mode, Status
- Power Supply, Steering Wheel Angle Sensor Module (SAS)
- Steering Wheel Angle
- Steering Wheel Angle Speed
- Steering Wheel Angle, Steering Direction
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.