Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Volvo S60 Base, FWDFACTORY OEM SERVICE PROCEDURE
Section 221 (Transmission Control Module Frozen Values - Description)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
- Transmission
- Frozen values for the transmission control module (TCM), description
- General information
- Diagnostic Trouble Code (DTC)
- Counter 2
- Engine, status
- Outside temperature
- Counts - the operating cycles since the diagnostic trouble code (DTC) was first/last stored
- Time since the diagnostic trouble code (DTC) was first/last stored
- The voltage in the central electronic module when the diagnostic trouble code (DTC) was first/last stored
- Total mileage since the diagnostic trouble code (DTC) was first / last stored
- Passenger compartment temperature
- Oil temperature
- Gear ratios
- Expected gear ratio
- Calculated speed of the signal from the transmission speed sensor (output speed)
- Speed signal, calculated from the engine speed (RPM)
- Gear according to the shift solenoids
- Gear-shift position sensor
- Accelerator pedal (AP) position
- Transmission speed sensor, output speed
- Transmission speed sensor, input speed
- Gear-shift position sensor, position
- Engine speed (RPM)
- Position of the gear-shift position sensor ABCPA
- System voltage
- Engine torque
- Engine coolant temperature (ECT)
- Kickdown, status
- Gear according to solenoids
- Frozen values for the transmission control module (TCM), description
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
