Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
System Overview: Signals
The table below summarizes the input signals to and output signals from the electrical power steering module (EPS).
The signal types are divided into directly connected signals and Controller area network (CAN) communication. The illustration below (Fig 1) displays the same information with the Volvo component designations.
| Input signals | Output signals |
| Directly connected: | Directly connected: |
Ignition
(3/1):
|
- |
| Via Controller Area Network (CAN) communication: | Via Controller Area Network (CAN) communication: |
Steering wheel module (SWM)
(3/254):
Brake control module (BCM) (4/16):
Engine control module (ECM) (4/46):
Central electronic module (CEM) (4/56): |
Driver information module (DIM)
(5/1):
|
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.