Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnostic Trouble Code (DTC) Information KVM-0015
Condition
The keyless vehicle module (KVM) checks the connection with the connected antenna when the vehicle speed exceeds 20 km/h (12 mph). The check occurs every 5th operating cycle.
The diagnostic trouble code (DTC) is stored if the control module registers that the there is no signal from the outer left-hand antenna circuit.
The diagnostic trouble code (DTC) can always be diagnosed when the car is supplied with power.
Substitute Value
- None.
Possible Source
- A part of the circuit to the exterior, left-hand antenna is not connected.
- Exterior, left-hand antenna damaged or not connected.
Fault symptom[s]
- No, or reduced, keyless functionality.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.