Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO2007XC90 AWD V8-4.4L VIN 85 B8444SREPAIR AND DIAGNOSISA L L DIAGNOSTIC TROUBLE CODES ( DTC )TESTING AND INSPECTIONP CODE CHARTSP0107DIAGNOSTIC TROUBLE CODE (DTC) INFORMATION
2007 Volvo XC90 AWD V8-4.4L VIN 85 B8444S
Diagnostic Trouble Code (DTC) Information
2007 Volvo XC90 AWD V8-4.4L VIN 85 B8444SSECTION Diagnostic Trouble Code (DTC) Information
Diagnostic trouble code (DTC) information ECM-P010700
Condition
The engine control module (ECM) measures the air pressure in the intake manifold using an air pressure sensor.
The diagnostic trouble code (DTC) is stored if the Engine Control Module (ECM) detects that the signal from the manifold absolute pressure (MAP) sensor in the intake manifold is too low.
The diagnostic trouble code can be diagnosed when the ignition is on.
Substitute value
- The signal from the air pressure sensor in the intake manifold is set to a constant.
- Load/airflow calculations are carried out regardless of the signal from the air pressure sensor.
Possible source
- The signal cable is short-circuited to ground.
- Damaged air pressure sensor in the intake manifold.
Fault symptom[s]
- Malfunction indicator lamp (MIL) lit.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.