Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO2007XC90 AWD V8-4.4L VIN 85 B8444SREPAIR AND DIAGNOSISA L L DIAGNOSTIC TROUBLE CODES ( DTC )TESTING AND INSPECTIONMANUFACTURER CODE CHARTSPSM CODES (POWER SEAT MODULE)PSM-002AINTERMITTENT FAULTTOO LONG TIME
2007 Volvo XC90 AWD V8-4.4L VIN 85 B8444S
Too Long Time
2007 Volvo XC90 AWD V8-4.4L VIN 85 B8444SSECTION Too Long Time
Too long time. Intermittent fault
Checking control panel
Check the power seat module (PSM) and the control panel connectors. Check for intermittent short-circuit to ground. See Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Check for contact resistance and oxidation. See Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Check for loose connections. See Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals.
Remedy as necessary.
Other information:
- To connect the breakout box, see Connecting the breakout box, power seat module (PSM) Connecting the Breakout Box, Power Seat Module (PSM)
- For information about signals, see Signal specification, Power seat module Signal Specification, Power Seat Module (PSM).
Continue - DONE
-------------------------------------------------
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.