Diagnostic Trouble Code (DTC) Information

2007 Volvo XC90 AWD V8-4.4L VIN 85 B8444SSECTION Diagnostic Trouble Code (DTC) Information





Diagnostic trouble code (DTC) information CEM-8F52

Condition




The Central electronic module (CEM) checks the output signal to the relay winding for headlight cleaning.
If Central electronic module (CEM) registers that the output signal to the relay winding is missing or too low, the diagnostic trouble code is generated.
The diagnostic trouble code (DTC) can be diagnosed when the ignition is switched on.

Substitute value
- None.

Possible source
- The washer pump's fuse has failed.
- Open-circuit or short-circuit to ground in the signal cable.
- Damaged relay.
- Short-circuiting in the pump for high-pressure washing.

Fault symptom[s]
- Headlight washer pump does not work

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.