Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO2007XC90 AWD V8-4.4L VIN 85 B8444SREPAIR AND DIAGNOSISA L L DIAGNOSTIC TROUBLE CODES ( DTC )TESTING AND INSPECTIONMANUFACTURER CODE CHARTSCEM CODES (CENTRAL ELECTRONIC MODULE)CEM-5F40DIAGNOSTIC TROUBLE CODE (DTC) INFORMATION
2007 Volvo XC90 AWD V8-4.4L VIN 85 B8444S
Diagnostic Trouble Code (DTC) Information
2007 Volvo XC90 AWD V8-4.4L VIN 85 B8444SSECTION Diagnostic Trouble Code (DTC) Information
Diagnostic trouble code (DTC) information CEM-5F40
Condition
The central electronic module (CEM) checks the communication with the combustion preheater module (CPM).
The diagnostic trouble code (DTC) is stored if the central electronic module (CEM) registers that the signal in the circuit for the fuel pump (FP) is too low.
The diagnostic trouble code (DTC) can be diagnosed when the heater is activated.
Substitute value
- None.
Possible source
- Contact resistance in the control module or fuel pump connectors
- Short-circuit to ground in the signal cable
- Open-circuit in the signal cable
- Open-circuit in the power cable
- Damaged overheat protection thermostat
- Damaged fuel pump.
Fault symptom[s]
- Poor heating in the passenger compartment.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.